3 Spectrum Analyzer Mode
3.8 Spurious Emissions Measurement
State Saved Yes
Min/Max -79999990/SA Max Frequency (Hardware Dependent)
Offset Side
Sets the offset side to either Negative or Positive. This parameter indicates which
side of the operation band the specified range is on. It also determines which
coupling equations defined in Frequency Type section are used to couple the
absolute frequencies and the offset frequencies. This setting is effective only when
"Frequency Type" on page 1450 is OFFset.
Remote
Command
[:SENSe]:SPURious[:RANGe][:LIST]:OFFSet:SIDE NEGative | POSitive, NEGative |
POSitive, NEGative | POSitive, NEGative | POSitive, NEGative | POSitive,
NEGative | POSitive, NEGative | POSitive, NEGative | POSitive, NEGative |
POSitive, NEGative | POSitive, NEGative | POSitive, NEGative | POSitive,
NEGative | POSitive, NEGative | POSitive, NEGative | POSitive, NEGative |
POSitive, NEGative | POSitive, NEGative | POSitive, NEGative | POSitive,
NEGative | POSitive
[:SENSe]:SPURious[:RANGe][:LIST]:OFFSet:SIDE?
Example
:SPUR:OFFS:SIDE NEG, NEG, POS, POS
:SPUR:OFFS:SIDE?
Preset
NEG, NEG, POS, POS, POS, POS, POS, POS, POS, POS, POS, POS, POS, POS, POS,
POS, POS, POS, POS, POS
State Saved Saved in instrument state
Range Negative (From Op. Band Start Edge)|Positive (From Op. Band Stop Edge)
Filter/Atten
Lets you set Attenuation and IF Gain values for each Range. This tab appears in all
Modes except MSR.
Frequency Range
Allows you to switch the displayed Frequency Range columns. When ALL is
selected, Start Frequency, Stop Frequency, Center Frequency, and Span are
displayed.
This control appears only in instruments with a 4U size front panel.
Remote
Command
:DISPlay:SPURious:VIEW:RANGe:TABLe:FMODe ALL | SSTop | CSPan
:DISPlay:SPURious:VIEW:RANGe:TABLe:FMODe?
Example
:DISP:SPUR:VIEW:RANG:TABL:FMOD ALL
:DISP:SPUR:VIEW:RANG:TABL:FMOD?
1454 Spectrum Analyzer Mode User's &Programmer's Reference
To Next Page
Loading...
Need help?
General
