7 Save/Recall/Print
7.2 Recall
directory to ARB memory is rejected with an error. When Include Source is No and there is insufficient
free ARB memory to load all the waveforms, when the ARB memory is full, the copy ceases, and an error
is generated
7.2.14.2 Delete Segment From ARB Mem
Deletes a segment from ARB memory.
Remote
Command
:SOURce:RADio:ARB:DELete <string>
<string> specifies the waveform to be deleted from the ARB playback memory
Example
:SOUR:RAD:ARB:DEL "testwaveform.bin"
Notes It is possible to delete files from within the ARB memory when the ARB is ON. However, if you attempt
to delete the file that is currently playing an error is generated
It is possible to delete a file from within the ARB memory when the sequencer state is ON, and the file is
not being used by the List Sequencer. If you attempt to delete a file that is being used by the list
sequencer, an error is generated
When the Sequencer state of the List Sequencer is On, even if ARB state is On, the selected waveform
will not be played. In this case, if the selected waveform is not used in List Sequence, it can be deleted,
and the ARB state is turned Off
If the ARB is ON and you load a file to ARB memory or delete a file from ARB memory, the playing
waveform segment may not keep phase continuity during the ARB memory operation. The waveform is
replayed after the ARB operation is finished
When in Sequence Analyzer Mode, and Include Source is Yes, an attempt to delete a file from ARB
memory is rejected with an error . When Include Source is No, and you specify a file that does not exist
within ARB memory, an error is generated
7.2.14.3 Delete All From ARB Memory
Removes all segments from ARB memory.
Remote
Command
:SOURce:RADio:ARB:DELete:ALL
Example
:SOUR:RAD:ARB:DELete:ALL
Notes If you attempt to delete all files from ARB memory when there are waveform files used in the Sequencer
function of the List Sequencer and the Sequencer state is ON, all files except the files currently being
used in list sequencer are deleted, and an error is generated
If the ARB is ON and you load a file to ARB memory or delete a file from ARB memory, the playing
waveform segment may not keep phase continuity during the ARB memory operation. The waveform is
replayed after the ARB operation is finished
When in Sequence Analyzer Mode, and Include Source is Yes, an attempt to delete all files from ARB
memory is rejected with an error. When Include Source is No, and you attempt to delete all files from
ARB memory when the ARB is currently playing a file, all files except the one playing are deleted and an
error is generated
Spectrum Analyzer Mode User's &Programmer's Reference 2548
To Next Page
Loading...
Need help?
General
