3 Spectrum Analyzer Mode
3.2 Swept SA Measurement
Backwards
Compatibility SCPI
:TRACe:DISPlay:VIEW:SPECtrogram:TIME <time>
Couple Marker To Display Trace
Couples the marker to the selected "Display Trace" on page 259. When OFF, this lets
you fix the marker to the Display Trace that was active when the marker was turned
on. When ON, the marker stays with the selected Display Trace as it is changed.
Remote Command
:DISPlay:VIEW:SPECtrogram:TRACe:COUPle ON | OFF | 1 | 0
:DISPlay:VIEW:SPECtrogram:TRACe:COUPle?
Example
:DISP:VIEW:SPEC:TRAC:COUP ON
Dependencies Only appears when the Waterfall window is visible, and either the Waterfall or Spectrum window is
selected
If the command is sent at any other time, it is accepted without error, but you will not see the result
until you once again display the Waterfall window
Preset
OFF
State Saved Saved in instrument state
Color Adjust
Lets you adjust the color mapping of the Spectrogram display. Adjusting the color
map can help you find an array of colors whose contrast is more ideally suited to
your signal, or to exclude regions of the display that you do not wish to see. See
"Examples" on page 263 below.
Spectrum Analyzer Mode User's &Programmer's Reference 261
To Next Page
Loading...
Need help?
General
