Keysight x-series User Manual

3 Spectrum Analyzer Mode
3.7 Burst Power Measurement
–
Zero span measurement Resolution Bandwidth
–
Zero span measurement Dwell Time
Harmonics (SA Mode only)
Parameters affected by Auto Couple are:
–
Resolution Bandwidth
–
Fundamental Frequency
–
Dwell Time
–
Range Table Resolution Bandwidths
–
Range Table Dwell Times
Meas Preset
Returns parameters for this measurement to their factory default settings.
Remote Command
:CONFigure:TXPower
Example
:CONF:TXP
3.7.8.2 Meas Method
Lets you choose and configure the Measurement Method.
Meas Method
There are two options for this parameter:
Above
Threshold
Level
THReshold
This measurement algorithm is used to capture a time record,
and average only those points in the time record that exceed
the user-specified threshold level. No attempt is made to
position the burst, or to calculate/display burst widths. This
can be used to measure continuous signals, or bursted signals
where the Measured Burst Width algorithm is too restrictive
Measured
Burst Width
BWIDth
This measurement algorithm uses the threshold level to
calculate the burst center, and average those points that lie
within a user-specified burst width that is centered upon the
burst. The burst width parameter is described in more detail
below
Spectrum Analyzer Mode User's &Programmer's Reference 1323

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)