6 Input/Output
6.9 Calibration
6.9.1.5 Copy From Cal Group
Determines the Cal Group from which existing rows are copied when using the
"Copy" on page 2487Group feature.
Remote
Command
:SYSTem:CALibration:CGRoup:COPY:FROM <integer>
:SYSTem:CALibration:CGRoup:COPY:FROM?
Example
:SYST:CAL:CGR:COPY:FROM 2
:SYST:CAL:CGR:COPY:FROM?
Preset 1
Min 1
Max 100
6.9.1.6 Copy
Lets you copy the settings in the Cal Group specified by the Copy From Cal Group
parameter.
All the rows in the table are copied to the selected Cal Group. The columns Apply,
Last Cal and Applied are set to their default values.
The group level parameters are also copied, with the exception of Apply Cal Group
and Copy From Cal Group.
Remote Command
:SYSTem:CALibration:CGRoup:COPY
Example
:SYST:CAL:CGRoup:COPY
Dependencies Applied to the currently selected Cal Group
Couplings Disabled if Copy From Cal Group is the same as the currently selected Cal Group. If the disabled
control is selected, the advisory message “Unable to Copy from same Cal Group” is displayed, and the
same message is returned remotely as a Settings Conflict
If you attempt to copy from a Cal Group that is empty, the advisory message “Copy From Cal Group is
empty” is displayed, and the same message is returned remotely as a Settings Conflict
Spectrum Analyzer Mode User's &Programmer's Reference 2487
To Next Page
Loading...
Need help?
General
