Keysight x-series User Manual

6 Input/Output
6.9 Calibration
6.9.1.18 Duplicate Row
Creates a new row the currently selected row, and populates the new row with the
settings from the selected row of the currently selected Cal Group
Remote Command
:SYSTem:CALibration:ROW[1]|2|…|100:DUPLicate
Example
:SYST:CAL:ROW2:DUPL
Dependencies The SCPI command is applied to the currently selected Cal Group. The subopcode is used to identify
the Cal row in the Cal Group
If the subopcode does not reference an existing Cal row in the Cal Group, the error message “-
221,Settings conflict; Subopcode does not reference an existing Cal row” is generated
6.9.1.19 Delete Row
Deletes the settings from the selected row of the currently selected Cal Group
Remote Command
:SYSTem:CALibration:ROW[1]|2|…|100:DELete
Example
:SYST:CAL:ROW2:DEL
Notes Disabled if the Cal Group contains no Cal rows
Dependencies The SCPI command is applied to the currently selected Cal Group. The subopcode is used to identify
the Cal row in the Cal Group
If the subopcode does not reference an existing Cal row in the Cal Group, the error message “-221,
Settings conflict; Subopcode does not reference an existing Cal row” is generated
6.9.1.20 Delete All
Deletes all the Cals in the currently selected Cal Group
Remote Command
:SYSTem:CALibration:DELete:ALL
Example
:SYST:CAL:DEL:ALL
Notes Disabled if the Cal Group contains no Cal rows
Dependencies The SCPI command is applied to the currently selected Cal Group
6.9.1.21 Calibrate
Determines whether the Cal row should be included when Calibrate Selected is
executed.
Remote Command
:SYSTem:CALibration:ROW[1]|2|…|100:CALibrate:STATe ON | OFF | 1 | 0
:SYSTem:CALibration:ROW[1]|2|…|100:CALibrate:STATe?
Spectrum Analyzer Mode User's &Programmer's Reference 2493

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)