Keysight x-series User Manual

3 Spectrum Analyzer Mode
3.5 ACP Measurement
returned after an unsuccessful search
Notes Sending this command selects the subopcoded marker
Next Peak
Moves the selected marker to the peak that is next lower in amplitude than the
current marker value.
If the selected marker was OFF, then it is turned on as a normal marker and a peak
search is performed.
Remote Command
:CALCulate:ACPower:MARKer[1]|2|…|12:MAXimum:NEXT
Example
:CALC:ACP:MARK2:MAX:NEXT
Notes Sending this command selects the subopcoded marker
State Saved Not part of saved state
Next Pk Right
Moves the selected marker to the nearest peak right of the current marker.
If the selected marker was OFF, then it is turned on as a normal marker and a peak
search is performed.
Remote Command
:CALCulate:ACPower:MARKer[1]|2|…|12:MAXimum:RIGHt
Example
:CALC:ACP:MARK2:MAX:RIGH
Notes Sending this command selects the subopcoded marker
State Saved Not part of saved state
Next Pk Left
Moves the selected marker to the nearest peak left of the current marker.
If the selected marker was OFF, then it is turned on as a normal marker and a peak
search is performed.
Remote Command
:CALCulate:ACPower:MARKer[1]|2|…|12:MAXimum:LEFT
Example
:CALC:ACP:MARK2:MAX:LEFT
State Saved Not part of saved state
Minimum Peak
Moves the selected marker to the minimum Y-Axis value on the current trace.
Spectrum Analyzer Mode User's &Programmer's Reference 965

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)