Keysight x-series User Manual

3 Spectrum Analyzer Mode
3.12 List Sweep Measurement (Remote Only)
State Saved Saved in instrument state
Range Same as the RBW values available in the Swept SA measurement
Remote
Command
[:SENSe]:LIST:BANDwidth|BWIDth:RESolution:POINts?
Example
LIST:BAND:RES:POIN?
3.12.3.6 VBW List
This command defines a list of analyzer VBW settings at which the measurements
are made.
The query form queries the analyzer for the values in the VBW list.
Remote
Command
[:SENSe]:LIST:BANDwidth|BWIDth:VIDeo <freq>[, <freq>]
[:SENSe]:LIST:BANDwidth|BWIDth:VIDeo?
Example
LIST:BAND:VID 10KHZ
Preset Current Video BW value from Swept SA measurement
State Saved Saved in instrument state
Range Same as the Video BW values available in the Swept SA measurement.
Remote
Command
[:SENSe]:LIST:BANDwidth|BWIDth:VIDeo:POINts?
Example
LIST:BAND:VID:POIN?
3.12.3.7 Sweep Time List
This command defines a list of analyzer sweep times at which the measurements are
made. In zero span measurements, this is the time required to measure a single
point given the current setting for the number of points in the sweep.
The query form queries the analyzer for the values in the sweep time list.
Remote Command
[:SENSe]:LIST:SWEep:TIME <time>[, <time>]
[:SENSe]:LIST:SWEep:TIME?
Preset Current Sweep Time value from Swept SA measurement
State Saved Saved in instrument state
Range Same as the Sweep Time range available in the Swept SA measurement.
Spectrum Analyzer Mode User's &Programmer's Reference 1939

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)