Keysight x-series User Manual

9 Programming the Instrument
9.4 Status Register System & STATus Subsystem
Bit Condition Operation
0 ODI Connection Error ODI Connection Error
This bit is never triggered, only its aliases are
Filter Registers
–
"Questionable Integrity Output Condition" on page 2827
–
"Questionable Integrity Output Enable" on page 2827
–
"Questionable Integrity Output Event Query" on page 2828
–
"Questionable Integrity Output Negative Transition" on page 2828
–
"Questionable Integrity Output Positive Transition" on page 2829
Questionable Integrity Output Condition
Returns the decimal value of the sum of the bits in the Questionable Integrity Output
Condition register.
NOTE
The data in this register is continuously updated and reflects the current
conditions.
Remote
Command
:STATus:QUEStionable:INTegrity:OUTPut:CONDition?
Example
:STAT:QUES:INT:OUTP:COND?
Preset 0
Status Bits/OPC
dependencies
Sequential command
Questionable Integrity Output Enable
Determines which bits in the "Questionable Integrity Output Condition" on page
2827 register will set the corresponding bit in the "Questionable Integrity Output
Event Query" on page 2828 register, which also sets the Data Output Summary bit
(bit 2) in the "Questionable Integrity Register" on page 2819.
The variable <integer> is the sum of the decimal values of the bits that you want to
enable.
Remote
Command
:STATus:QUEStionable:INTegrity:OUTPut:ENABle
:STATus:QUEStionable:INTegrity:OUTPut:ENABle?
Example
:STAT:QUES:INT:OUTP:ENAB 1
2827 Spectrum Analyzer Mode User's &Programmer's Reference

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)