7 Save/Recall/Print
7.3 Save
MeasResult1 contains the same results as MEAS/READ/FETCh:TXPower|BPOWer1;
MeasResult2, MEAS/READ/FETCh:TXPower|BPOWer2; and so on.
The exported file has .csv extension. A typical Meas Results file, when imported into
Excel, would appear as follows:
MeasResult
SA:TXP
A.10.53 N9030A
526 ALV ATP B1X B1Y B25 B40 BBA
CR3 CRP DCF DDA DP2 DRD EA3
EDP EMC EP1 ERC ESC ESP EXM
FSA LFE LNP MAT MPB NFE NUL
P26 PFR PNC RTL RTS S40 SB1 SEC
SM1 TVT YAS YAV
1
Center Frequency 1.33E+10
TXP_InfoBw 3000000
TXP_Used_CaptureTime 0.00064
MeasResult1 MeasResult2 MeasResult3 MeasResult4
0
-999
7.3.6 Limit
Lets you choose a file to which to export the Limit data.
Limit files are CSV files, and contain the limit data in a form that can be imported
into Excel or similar spreadsheets, as well as header data that gives information on
the limit.
The default path for most Limits files is:
My Documents\<mode name>\data\limits
where <mode name> is the parameter used to select the mode with the :INST:SEL
command (for example, SA for Spectrum Analyzer). Hence a Limit file from any
measurement in Spectrum Analyzer Mode would be stored in:
My Documents\SA\data\limits
The default path for Limit files from the Log Plot measurement in Phase Noise Mode
is:
My Documents\PNOISE\data\LPL\limits
The default filename is Limit_0000.csv, where the 4-digit number is the lowest
number that does not conflict with any filename in the current directory.
2609 Spectrum Analyzer Mode User's &Programmer's Reference
To Next Page
Loading...
Need help?
General
