Keysight x-series User Manual

2 User Interface
2.17 View Editor
Measurement Name SCPI ID
Transmit Analysis
TX
Transmit On/Off Power
PVTime
Transmit Power
(Burst Power)
TXPower
Tuned RF Level
TRFLevel
Tuned RF Level with Tracking
TTRF
Tx Band Spur
ETSPur
VHF Omni-Directional Range
VOR
Examples:
–
The User View file for the Swept SA measurement is SA.SANalyzer.layout
–
The User View file for the ACP measurement in the WCDMA mode is
WCDMA.ACPower.layout
Copy the desired file to a thumb drive or to your network. Then go to the target
instrument and copy the file into the D:\Users\Instrument\My
Documents\UserViews directory on that instrument (again, assuming you are
logged in as Instrument).
Note that copying this file to another instrument will overwrite the file already in that
instrument, if any, and will destroy any User Views that might have been created on
that instrument.
Note that when you delete the last User View for a measurement, the file is removed.
2.17.5 To Rename a User View
You can rename a User View by selecting that View and tapping “Rename User
View.” You can also re-edit a User View; if you do this, an asterisk will appear next to
the User View’s name. You can then tap “Re-Save User View to save it back to its
existing name, or “Save Layout as New View” to add another, new User View.
2.17.6 To Delete a User View
You can delete a User View by doing the following:
1.
From the "Mode/Meas/View Dialog" on page 88, or from the View menu, select
the User View that you want to delete
2.
Switch to the Display menu
173 Spectrum Analyzer Mode User's &Programmer's Reference

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)