Keysight x-series User Manual

6 Input/Output
6.1 RF Source
Parameter SCPI Example Notes
“Local Host” indicates that the Primary and Secondary
modules share the same chassis
Slot Number :SOUR:SYNC:REM:SEC2:SLOT? Indicates the slot number of available models
Socket Port :SOUR:SYNC:REM:SEC2:SPOR? Indicates the socket port of available models
Secondary module
Order
Shows you the models to be Secondary devices
Use Selected to choose from available Secondary models
Sync Settings
Lets you apply the source settings of the Primary module to its Secondary modules.
Remote Command
:SOURce:SYNC:SETTings:ENABle ON | OFF | 1 | 0
:SOURce:SYNC:SETTings:ENABle?
Example
:SOUR:SYNC:SETT:ENAB ON
:SOUR:SYNC:SETT:ENAB?
Notes When Sync Settings is ON, the source settings of Primary are applied to Secondary modules. The
supported settings are Amplitude, Frequency, Trigger Source, Trigger Type, RF Output and waveform
related information
When Sync Segment 2 is switched ON, this Toggle is set ON simultaneously
Dependencies Waveform files naming convention:
For NxN MIMO:
–
xxx0.wfm for Primary
–
xxx[n].wfm for TRX[n]
For example, in 3x3 MIMO:
–
xxx0.wfm for Primary
–
xxx1.wfm for TRX1
–
xxx2.wfm for TRX2
For NxN+NxN MIMO, in the first group:
–
xxx0_0.wfm for Primary
–
xxx0_n.wfm for TRX[n]
in the second group:
–
xxx1_n.wfm for TRX[n+N]
For example, in 3x3+3x3 MIMO:
–
xxx0_0 for Primary
2326 Spectrum Analyzer Mode User's &Programmer's Reference

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)