Keysight x-series User Manual

3 Spectrum Analyzer Mode
3.9 SEM Measurement
–
Span/RBW Ratio
–
Sweep Time
–
Video BANDwidth VBW/RBW ratio
–
Upper and Lower Tone (set to Sense)
–
Zero span measurement Resolution Bandwidth
–
Zero span measurement Dwell Time
Harmonics (SA Mode only)
Parameters affected by Auto Couple are:
–
Resolution Bandwidth
–
Fundamental Frequency
–
Dwell Time
–
Range Table Resolution Bandwidths
–
Range Table Dwell Times
Meas Preset
Restores all the measurement parameters to their default values.
Remote Command
:CONFigure:SEMask
Example
:CONF:SEM
Couplings Restores all measurement parameters to their default values
3.9.18.2 Carrier
Used to set up parameters that define how the reference channel is measured.
Integ BW
Specifies the integration bandwidth used to calculate the power in the reference
channel.
Remote Command
[:SENSe]:SEMask:BANDwidth[1]|2:INTegration <bandwidth>
Spectrum Analyzer Mode User's &Programmer's Reference 1687

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)