To Next Page

To Previous Page

6 Input/Output

6.9 Calibration

Calibration is > 3.6GHz, then this parameter is grayed out

If the Internal Preamp is on, meaning it is set to Low Band or Full, the electronic attenuator is

unavailable, then this parameter is grayed out

If either of the above is true, and if the SCPI command is sent, an error indicating that the electronic

attenuator is unavailable is sent

If both of the above are true, pressing the control generates error message -221, in other words, the

frequency range lockout takes precedence

For SCPI, this query applies to the currently selected Cal Group

If the subopcode does not reference an existing Cal row in the Cal Group, the error message “-221,

Settings conflict; Subopcode does not reference an existing Cal row” is generated

Couplings Coupled to Elec Atten Start. Elec Atten Stop must be >= Elec Atten Start. If Elec Atten Stop < Elec

Atten Start, Elec Atten Start = Elec Atten Stop

Preset 0dB

State Saved Saved in instrument state

Min 0dB

Max 24dB

6.9.1.38 Elec Atten Step

Determines the Elec Attenuation Step. This determines the points between the

Electric Attenuation min and max to use for Calibration.

Remote Command

:SYSTem:CALibration:ROW[1]|2|…|100:EATTenuation:STEP <rel_ampl>

:SYSTem:CALibration:ROW[1]|2|…|100:EATTenuation:STEP?

Example

:SYST:CAL:ROW2:EATT:STEP 2dB

Dependencies Disabled unless "Elec Atten Type" on page 2501 is STEP

The SCPI command applies to the currently selected Cal Group

If the subopcode does not reference an existing Cal row in the Cal Group, the error message “-221,

Settings conflict; Subopcode does not reference an existing Cal row” is generated

Preset 1dB

State Saved Saved in instrument state

Min 1dB

Max 24dB

6.9.1.39 Full Range Atten Type

Specifies the Full Range Atten type to use. The Full Range Attenuator adds a second

input attenuator at the beginning of the RF Input 2, which enhances the protection

and optimizes the performance of the extra internal mixers used by RF Input 2.

Spectrum Analyzer Mode User's &Programmer's Reference 2503

Keysight x-series User Manual

Other manuals for Keysight x-series