Keysight x-series User Manual

7 Save/Recall/Print
7.3 Save
instrument software upgrade
The SCPI parameter is a quoted string, which specifies the filename. Both single and double quotes
are supported for any filename parameter over SCPI
Annotation After the save is complete, an advisory is displayed in the window so that the user can confirm which
file was saved
Status Bits/OPC
dependencies
Sequential – waits for the previous measurement to complete
CHP Meas Results File Contents
The file contains measurement results, preceded by the following header
information.
–
File ID string, which is MeasResult
–
Mode ID: Measurement ID, for example, SA:CHP
–
Firmware rev and model number
–
Option string
–
Auto Sweep Time Rules
–
Average Mode
–
Average Number
–
Average State
–
Center Frequency
–
Detector
–
Electrical Atten
–
Electrical Atten State
–
IFGain
–
IFGainAuto
–
Impedance
–
Integ BW
–
Internal Preamp
2583 Spectrum Analyzer Mode User's &Programmer's Reference

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)