Keysight x-series User Manual

6 Input/Output
6.5 Corrections
Correction Port SCPI Note
Current Input
CINPut
The correction will be applied to whichever input is currently selected in the Input
menu
RF Input
RFIN
Main RF Port
Not available on EXM with hardware M9431A
RF Input 2
RFIN2
Second RF Port, labeled RF Input 2
Only available on certain instruments. Not available on modular instruments
BBIQ input
AIQ
Requires option BBA
Not available on modular instruments
External Mixer
EMIXer
Requires option EXM
Not available on modular instruments
Antenna
ANT
Antenna input port on M9470A, labeled Ant
Generator
GEN
Generator output port on M9470A, labeled Gen
T/R
TR
T/R port on M9470A, labeled T/R
RF Full Duplex
RFFD
On modular instruments, labeled RFFD. Option “FDX” is required to enable RFFD port
RF Half Duplex
RFHD
On modular instruments, labeled RFHD. Option “HDX” is required to enable RFHD port
A1
A1
On E7760B
A2
A2
On E7760B
A3
A3
On E7760B
B1
B1
On E7760B
B2
B2
On E7760B
B3
B3
On E7760B
IFIO1
IFIO1
On E7760B
IFIO2
IFIO2
On E7760B
RF Output
RFOut
Appears on some modular instruments
Not available on EXM with hardware M9431A
RFIO1
RFIO1
Appears on some modular instruments
RFIO2
RFIO2
Appears on some modular instruments
RFIO3
RFIO3
Only available in EXM with hardware M9431A
RFIO4
RFIO4
Only available in EXM with hardware M9431A
GPS out
GPS
Appears on some modular instruments
GNSS out
GNSS
Appears on some modular instruments
6.5.4 Correction Direction
Selects whether corrections will be applied when the device associated with the
specified correction is being used as an input, an output or in both directions. The
choices are:
2422 Spectrum Analyzer Mode User's &Programmer's Reference

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)