Keysight x-series User Manual

3 Spectrum Analyzer Mode
3.7 Burst Power Measurement
Preset
ON
Range
OFF|ON
Backwards Compatibility
SCPI
[:SENSe]:BPOWer:AVERage[:STATe]
Avg Mode
Selects the type of termination control used for the averaging function. This
determines the averaging action after the specified number of data acquisitions
(average count) is reached.
Control SCPI Mode
Exponential
EXPonential
After the average count is reached, each successive data
acquisition is exponentially weighted and combined with
the existing average
Repeat
REPeat
After reaching the average count, the averaging is reset
and a new average is started
Remote
Command
[:SENSe]:TXPower:AVERage:TCONtrol EXPonential | REPeat
[:SENSe]:TXPower:AVERage:TCONtrol?
Example
:TXP:AVER:TCON REP
:TXP:AVER:TCON?
Preset
EXPonential
State Saved Yes
Range
EXPonential|REPeat
Backwards
Compatibility
SCPI
[:SENSe]:BPOWer:AVERage:TCONtrol
Included for backwards compatibility. Not recommended for use in new designs
Avg Type
Specifies the type of trace and result averaging to use.
Control
Selection
SCPI Type
Power
Average (RMS)
RMS
True power averaging that is equivalent to taking the RMS value
of the voltage. It is the most accurate type of averaging
Log-Power
Average
(Video)
LOG
Simulates the traditional spectrum analyzer type of averaging by
averaging the log of the power
1318 Spectrum Analyzer Mode User's &Programmer's Reference

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)