Keysight x-series User Manual

3 Spectrum Analyzer Mode
3.3 Channel Power Measurement
3.3.7.3 Peak Search
The controls on this tab let you move the marker to selected peaks of the signal,
giving you enormous analysis capabilities, particularly when combined with "Marker
Delta" on page 637.
NOTE
Pressing the Peak Search hardkey automatically moves you to the Peak
Search page of the Marker menu and performs a peak search.
Pressing the Peak Search tab once you are already in the Marker menu does
not perform a peak search.
Marker Frequency
This is the fundamental control that you use to move a marker around on the trace.
It is the same as "Marker Frequency" on page 634 in the Settings tab.
Peak Search
Moves the selected marker to the trace point that has the maximum Y-Axis value for
that marker’s trace.
NOTE
Pressing the Peak Search hardkey automatically moves you to the Peak
Search page of the Marker menu and performs a peak search.
Remote
Command
:CALCulate:CHPower:MARKer[1]|2|…|12:MAXimum
Example
:CALC:CHP:MARK2:MAX
:SYST:ERR?
can be used to query the errors to determine if a peak is found. Following an unsuccessful search, the
message “No peak found” is returned
Notes Sending this command selects the subopcoded marker
In W-CDMA Mode, this command does not work when the selected marker is located on the polar
trace. In this case, the command is ignored
Marker Delta
Pressing this button has the same effect as pressing Delta in "Marker Mode" on
page 635 on the Settings tab. The selected marker becomes a Delta marker. If the
selected marker is already a Delta marker, the reference marker is moved to the
current position of the selected marker, thus resetting the delta to zero.
Spectrum Analyzer Mode User's &Programmer's Reference 637

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)