Keysight x-series User Manual

9 Programming the Instrument
9.4 Status Register System & STATus Subsystem
Status Bits/OPC depend-
encies
Sequential command
Operation Negative Transition
Determines which bits in the "Operation Condition Query" on page 2788 register will
set the corresponding bit in the "Operation Event Query" on page 2789 register
when the condition register bit has a negative transition (1 to 0).
The variable <integer> is the sum of the decimal values of the bits that you want to
enable.
Remote
Command
:STATus:OPERation:NTRansition <integer>
:STATus:OPERation:NTRansition?
Example
:STAT:OPER:NTR 1
Align Now operation complete will be reported to the Status Byte Register
Preset 0
Min 0
Max 32767
Status Bits/OPC
dependencies
Sequential command
Operation Positive Transition
Determines which bits in the "Operation Condition Query" on page 2788 register will
set the corresponding bit in the "Operation Event Query" on page 2789 register
when the condition register bit has a positive transition (0 to 1).
The variable <integer> is the sum of the decimal values of the bits that you want to
enable.
Remote
Command
:STATus:OPERation:PTRansition <integer>
:STATus:OPERation:PTRansition?
Example
:STAT:OPER:PTR 1
Align Now operation beginning will be reported to the Status Byte Register
Preset 32767
Min 0
Max 32767
Status Bits/OPC
dependencies
Sequential command
Spectrum Analyzer Mode User's &Programmer's Reference 2790

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)