To Next Page

To Previous Page

3 Spectrum Analyzer Mode

3.6 Power Stat CCDF Measurement

The Select Marker control appears above the menu panel, indicating that it applies

to all controls in the Marker menu panels. Select Marker is blanked if you select a

tab whose controls do not depend on the selected marker (for example, Counter).

For any menu that includes Select Marker, the first control is always Marker

Frequency | Time.

Notes The selected marker is remembered even when not in the Marker menu, and is used if a search is done,

or a Band Function is turned on, or for Signal Track or Continuous Peak

Preset Marker 1

State Saved The number of the selected marker is saved in instrument state

Annunciation Appears in the marker results block label for Normal and Delta markers

3.6.7.2 Settings

The controls on this tab include the Marker active function and a radio button

selection of the marker control mode (Position/Normal, Delta or Off) for the

selected marker, as well as additional functions that help you use markers.

Marker X-Axis Value

Sets the marker X-Axis value in the current marker X-Axis Scale unit. This function

has no effect if the control mode is Off, but is the remote command equivalent of

entering an X value if the control mode is Normal or Delta.

Remote

Command

:CALCulate:PSTatistic:MARKer[1]|2|…|12:X <rel_ampl>

:CALCulate:PSTatistic:MARKer[1]|2|…|12:X?

Example

:CALC:PST:MARK3:X 0

:CALC:PST:MARK3:X?

Notes If no suffix is sent, uses the fundamental units for the current marker X-Axis Scale. If a suffix is sent that

does not match the current marker X-Axis Scale unit, an error “Invalid suffix” is generated

The query returns the marker’s absolute X Axis value if the control mode is Normal, or the offset from

the marker’s reference marker if the control mode is Delta. The query is returned in the fundamental

units for the current marker X-Axis scale: Hz for Frequency and Inverse Time, seconds for Period and

Time. If the marker is Off the response is Not A Number

Preset After a preset, all Markers are turned OFF, so Marker X-Axis Value query returns Not a Number (NAN)

State Saved No

Min/Max –/+9.9E+37

Annotation Mkr # <X value> and <Marker value> upper right on graph

Marker Y Axis Value (Remote Command Only)

Queries the marker Y-Axis value in the current marker Y-Axis unit.

Spectrum Analyzer Mode User's &Programmer's Reference 1201

Keysight x-series User Manual

Other manuals for Keysight x-series