Keysight x-series User Manual

4 System
4.6 Alignments
–
Task 3 is the 20 Hz to 3.6 GHz alignment
Remote
Command
:CALibration:RFPSelector:SCHeduler:TASK T1 | T2 | T3
:CALibration:RFPSelector:SCHeduler:TASK?
Example
:CAL:RFPS:SCH:TASK T1
Notes Changing the task does not reset the Scheduler time, and the alignment is based on the current
scheduled configuration to occur
Preset Unaffected by Preset but set to T3 by Restore Defaults >"Alignments" on page 2100
State Saved No
Range Task 1 | Task 2 | Task 3
Date/Time
Lets you configure the scheduler to run a task starting from this date and time. The
date and time rely on the instrument’s local time to execute a scheduled task. The
date format is “YYYY/MM/DD” and the time is 24-hour clock.
Remote
Command
:CALibration:RFPSelector:SCHeduler:TIME:STARt ”date”,”time”
:CALibration:RFPSelector:SCHeduler:TIME:STARt?
This query returns data using the format ”YYYY/MM/DD; HH:MM:SS”
Example
:CAL:RFPS:SCH:TIME:STAR ”2009/8/20”,”12:00:00”
Notes “date” is the date the task will run, in the form YYYY/MM/DD where:
–
YYYY is the four-digit representation of year (for example, 2009)
–
MM is the two-digit representation of month (for example, 01 to 12)
–
DD is the two-digit representation of the day (for example, 01 to 28, 29, 30 or 31 depending on the
month and year)
“time” is the time of day the task will run, in the form HH:MM:SS where:
–
HH is the two-digit representation of the hour in 24-hour format
–
MM is the two-digit representation of minute
–
SS is the two-digit representation of seconds
Preset Unaffected by Preset but set to Current date and 00:00:00 by Restore Defaults >"Alignments" on page
2100
State Saved No
2175 Spectrum Analyzer Mode User's &Programmer's Reference

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)