Keysight x-series User Manual

3 Spectrum Analyzer Mode
3.2 Swept SA Measurement
:CALC:MARK2:FCO:GAT 1e-2
Notes When Auto Couple is pressed, Gate Time is set to 100 ms
This command causes the specified marker to become selected
Preset 100 ms
State Saved Saved in instrument state
Min 1 us
Max 500 ms
Auto Function
Remote
Command
:CALCulate:MARKer[1]|2|…|24:FCOunt:GATetime:AUTO OFF | ON | 0 | 1
:CALCulate:MARKer[1]|2|…|24:FCOunt:GATetime:AUTO?
Example
:CALC:MARK2:FCO:GAT:AUTO ON
Preset
ON
Backwards Compatibility Command
Notes Provided for ESA compatibility, which allowed you to control the gate resolution, rather than the gate
time
:CALCulate:MARKer[1]|2|3|4:FCOunt:RESolution <freq> Sets the gate time to
1/freq
:CALCulate:MARKer[1]|2|3|4:FCOunt:RESolution? Returns 1/gate_time
:CALCulate:MARKer[1]|2|3|4:FCOunt:RESolution:AUTO OFF|ON|0|1 is accepted
and ignored
:CALCulate:MARKer[1]|2|3|4:FCOunt:RESolution:AUTO? Always returns 1
All these commands cause the marker to become selected
Preset 1Hz
Backwards
Compatibility
SCPI
:CALCulate:MARKer[1]|2|…|4:FCOunt:RESolution <freq>
:CALCulate:MARKer[1]|2|…|4:FCOunt:RESolution?
Auto Function
Remote
Command
:CALCulate:MARKer[1]|2|…|4:FCOunt:RESolution:AUTO ON | OFF | 1 | 0
:CALCulate:MARKer[1]|2|…|4:FCOunt:RESolution:AUTO?
Preset
ON
3.2.8 Meas Setup
Contains functions for setting up the measurement parameters and for setting up
parameters global to all measurements in the Mode.
380 Spectrum Analyzer Mode User's &Programmer's Reference

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)