Keysight x-series User Manual

3 Spectrum Analyzer Mode
3.7 Burst Power Measurement
Min/Max SA, GSM
Relative: -100/0 dB
Absolute: -100/100 dBm
Annotation Both (Rel|Abs) threshold level are displayed on the 2nd window
If Threshold Type is set to Absolute, relative value is calculated from reference power level
If Threshold Type is set to Relative, absolute value is calculated from reference power level
Backwards
Compatibility
SCPI
[:SENSe]:BPOWer:THReshold
Included for backward compatibility. Not recommended for use in new designs
Threshold Type
Remote Command
[:SENSe]:TXPower:THReshold:TYPE ABSolute | RELative
[:SENSe]:TXPower:THReshold:TYPE?
Example
:TXP:THR:TYPE ABS
:TXP:THR:TYPE?
Preset
RELative
Range
ABSolute|RELative
Backwards Compatibility
SCPI
[:SENSe]:BPOWer:THReshold:TYPE
IF Gain
Used to set the IF Gain function to Auto, Low Gain or High Gain. These settings
affect sensitivity and IF overloads.
This only applies to the RF input. It does not apply to baseband I/Q input.
Remote Command
[:SENSe]:TXPower:IF:GAIN[:STATe] ON | OFF | 1 | 0
[:SENSe]:TXPower:IF:GAIN[:STATe]?
[:SENSe]:TXPower:IF:GAIN:AUTO[:STATe] ON | OFF | 1 | 0
[:SENSe]:TXPower:IF:GAIN:AUTO[:STATe]?
Example
:TXP:IF:GAIN ON
:TXP:IF:GAIN?
:TXP:IF:GAIN:AUTO OFF
:TXP:IF:GAIN:AUTO?
Notes ON = high gain
OFF = low gain
Dependencies IF Gain is not available when IQ Input is selected
The IF Gain control has no effect when the U7227A USB Preamplifier is connected. This is not
1320 Spectrum Analyzer Mode User's &Programmer's Reference

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)