3 Spectrum Analyzer Mode
3.9 SEM Measurement
# Item Unit
= 0 Others: dB
4
10k + 4, k
= 0
Absolute peak power on the negative offset A When "Measurement Type" on page 1700 is
PSD Ref: dBm/Hz
Others: dBm
5
10k + 5, k
= 0
Peak power offset frequency from the center or carrier edge
frequency in the negative offset A
Depends on the setting of "Offset Freq Define" on page 1642
Hz
6
10k + 6, k
= 0
Relative integrated power on the positive offset A
Returns NaN when "Measurement Type" on page 1700 is
Spectrum Peak Ref
When "Measurement Type" on page 1700 is
Total Power Ref: dBc
When PSD: dB
7
10k + 7, k
= 0
Absolute integrated power on the positive offset A
Returns NaN when "Measurement Type" on page 1700 is
Spectrum Peak Ref
When "Measurement Type" on page 1700 is
Total Power Ref: dBm
When PSD: dBm/Hz
8
10k + 8, k
= 0
Relative peak power on the positive offset A When "Measurement Type" on page 1700 is
Total Power Ref: dBc
Others: dB
9
10k + 9, k
= 0
Absolute peak power on the positive offset A When "Measurement Type" on page 1700 is
PSD Ref: dBm/Hz
Others: dBm
10
10k + 10,
k = 0
Peak power offset frequency from the center or carrier edge
frequency in the positive offset A
Depends on the setting of "Offset Freq Define" on page 1642
Hz
---
120
10k + 10,
k = 11
Peak power offset frequency from the center or carrier edge
frequency in the positive offset L
Depends on the setting of "Offset Freq Define" on page 1642
Hz
If the result is not available, NaN (9.91E+37) is returned
3.9.8 Results for n = 15
Results available only when "Measurement Type" on page 1700 is Total Power
Reference.
Returns comma-separated scalar results
For MSR, 5G NR, LTEAFDD, and LTEATDD Modes, returns outer offset results when
"Non-Contiguous Meas Region" on page 1622 is set to Outer or Outer & Inner
(5GNR, LTEAFDD, LTEATDD only), and returns inner offset results when it is set to
Inner
The results are in the following order:
Spectrum Analyzer Mode User's &Programmer's Reference 1535
To Next Page
Loading...
Need help?
General
