Keysight x-series User Manual

3 Spectrum Analyzer Mode
3.5 ACP Measurement
Measurement Type = PSD Ref
Remote
Command
[:SENSe]:ACPower:CARRier[1]|2:PREFerence:TYPE LRCarriers | MPCarrier | CINDex
| MANual | MPCSubblock | ACBandwidth | TMCarriers | MINPcarrier | MINSubblock
| LRSubblocks
[:SENSe]:ACPower:CARRier[1]|2:PREFerence:TYPE?
Subopcode: 1 = BTS/Downlink (Default), 2 = MS/Uplink
Example
:ACP:CARR:PREF:TYPE CIND
:ACP:CARR:PREF:TYPE?
Notes Available only in MSR, LTEAFDD, LTEATDD and 5G NR Modes
ACBandwidth is available only in LTEAFDD, LTEATDD and 5G NR Modes
TMCarriers is available only in MSR Mode
MINPcarrier,MINSubblock, and LRSubblocks are available only in 5G NR Mode
Note that Carrier subopcode 2 is not supported in some Modes. In those cases, Carrier subopcode 1 is
used for both BTS and MS and commands with subopcode 2 are accepted without error but ignored
Preset
MPCarrier
State Saved Saved in instrument state
Power Ref State (Remote Command Only)
Remote
Command
[:SENSe]:ACPower:CARRier[1]|2:AUTO[:STATe] OFF | ON | 0 | 1
Spectrum Analyzer Mode User's &Programmer's Reference 1059

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)