Keysight x-series User Manual

3 Spectrum Analyzer Mode
3.8 Spurious Emissions Measurement
(BTS) settings, for all relevant PowerSuite measurements. The Device SCPI
command has the same effect as a selection in the Radio column:
Remote
Command
[:SENSe]:RADio:STANdard:DEVice BTS | MS
[:SENSe]:RADio:STANdard:DEVice?
Example
:RAD:STAN:DEV MS
:RAD:STAN:DEV?
Preset
BTS
State Saved Saved in instrument state
Range
BTS|MS
Chart for Standard and Available Measurements
Note that not every measurement in Spectrum Analyzer Mode is available for every
standard. The chart below describes which measurements are available for each
Radio Standard.
For TOI or Harmonics measurements, no Radio Standards are available.
Swept
SA
CHP OBW ACP CCDF Burst
Power
Spurious
Emission
SEM List
Sweep
None X X X X X X X X (X)
3GPP 5G NR (X) X X X X X (X)
3GPP LTE (X) X X X X X (X)
3GPP W-CDMA (X) X X X X X X (X)
GSM/EDGE (X) X X (X)
cdma2000 1x (X) X X X X X (X)
IS-95A (X) X X X X X (X)
J-STD-008 (X) X X X X X (X)
IS-97D/98D (X) X X X X (X)
NADC (X) X X X X X (X)
PDC (X) X X X X X (X)
Bluetooth (X) X X (X)
W-LAN 802.11a (X) X (X)
W-LAN 802.11b (X) X (X)
W-LAN 802.11g (X) X (X)
W-LAN 802.11n (X) X X X X (X)
W-LAN
802.11ac
(X) X X X X (X)
W-LAN
802.11ax
(X) X X X X (X)
W-LAN (X) X X X X (X)
Spectrum Analyzer Mode User's &Programmer's Reference 1473

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)