Keysight x-series - Page 2565

7 Save/Recall/Print
7.3 Save
–
Number of Points
–
Sweep Time
–
Start Frequency
–
Stop Frequency
–
Average Count (actual; not the limit for the instrument)
–
Average Type
–
RBW
–
RBW Filter Type
–
RBW Filter BW Type
–
VBW
–
Sweep Type (FFT vs. Swept)
–
Log/Lin X Scale (sometimes called Log Sweep)
–
Preamp (on/off, band)
–
Trigger (source, level, slope, delay)
–
Phase Noise optimization setting
–
Swept IF Gain
–
FFT IF Gain
–
AC/DC setting (RF Coupling)
–
FFT Width
–
External Reference setting
–
Input (which input is in use)
–
RF calibrator on/off
–
Attenuation
Because any inactive trace can have a value that does not match the rest of the
measurement, when performing a Save the metadata for each trace is pulled from
the individual trace, not from the measurement.
A revision number is also included in the trace database, to allow for future changes.
2565 Spectrum Analyzer Mode User's &Programmer's Reference