Table Of Contents
Restore Defaults 1836
3.10.9 Sweep 1836
3.10.9.1 Sweep/Control 1836
Sweep Time 1836
Sweep/Measure 1838
Restart 1839
Pause/Resume 1842
Abort (Remote Command Only) 1842
3.10.9.2 Sweep Config 1843
Points 1843
IF Dithering 1844
Image Protection 1845
3.10.10 Trace 1845
3.10.10.1 Trace Control 1845
Trace Type 1846
Clear and Write | Restart Averaging | Restart Max/Min Hold 1847
3.11 Harmonics Measurement 1848
3.11.1 Views 1850
3.11.2 Windows 1851
3.11.2.1 Graph 1851
3.11.2.2 Metrics 1851
3.11.3 Amplitude 1851
3.11.3.1 Y Scale 1852
Ref Value 1852
Scale/Div 1852
Y Axis Unit 1853
Ref Level Offset 1858
Ref Position 1859
3.11.3.2 Attenuation 1859
Full Range Atten 1861
Mech Atten 1862
Elec Atten 1865
Adjust Atten for Min Clipping 1869
Adjust Atten 1869
Pre-Adjust for Min Clipping 1870
Mech Atten Step 1874
3.11.3.3 Range (Non-attenuator models) 1875
Range 1875
Adjust Range for Min Clipping 1876
Pre-Adjust for Min Clipping 1876
Peak-to-Average Ratio 1877
Mixer Lvl Offset 1878
Spectrum Analyzer Mode User's &Programmer's Reference 45
To Next Page
Loading...
