Keysight x-series User Manual

2 User Interface
2.1 Screen Tabs
and :CONF commands
Index to Modes
The Mode Number in the table below is the parameter for use with the
:INSTrument:NSELect command. The Mode Parameter is the parameter for use
with the :INSTrument[:SELect] command. Your actual choices will depend upon
which applications are installed in your instrument.
Mode Mode Number Mode Parameter
<mode_id>
5G NR 109
NR5G
89601 VSA 101
VSA89601
Analog Demod 234
ADEMOD
Avionics 232
AVIONIC
Bluetooth 228
BTooth
Channel Quality / Group Delay 161
CQM
EMI Receiver 141
EMI
GSM/EDGE/EDGE Evo 13
EDGEGSM
I/Q Analyzer (Basic) 8
BASIC
LTE FDD & LTE-A FDD 107
LTEAFDD
LTE TDD & LTE-A TDD 108
LTEATDD
Measuring Receiver 233
MRECEIVE
MSR 106
MSR
Noise Figure 219
NFIGure
Phase Noise 14
PNOISE
Power Amplifier 81
PA
Pulse 151
PULSEX
Radio Test 300
RTS
Real Time Spectrum Analyzer 2
RTSA
Remote Language Compatibility 266
RLC
SCPI Language Compatibility 270
SCPILC
Sequence Analyzer 123
SEQAN
Short Range Comms 218
SRCOMMS
Spectrum Analyzer 1
SA
Vector Modulation Analyzer 200
VMA
WCDMA with HSPA+ 9
WCDMA
WLAN 217
WLAN
91 Spectrum Analyzer Mode User's &Programmer's Reference

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)