Keysight x-series User Manual

Table Of Contents
Noise Source 448
SNS Attached (Remote Query Only) 450
ACP Enhanced Dynamic Range On/Off 451
3.2.8.7 Global 451
Global Center Freq 451
Global EMC Std 452
Global Limit Lines (Freq and Amptd) 453
Extend Low Band 453
Restore Defaults 454
3.2.8.8 Source 454
RF Output 455
Source Amplitude 456
Tracking Peak 456
Source Mode 457
Source Setup Table 460
Point Trigger 461
Manual Track Delay 466
Save/Restore Source State 466
Power Sweep 467
Amptd Offset 468
Amptd Step 469
Multiplier Numerator 470
Multiplier Denominator 470
Source Sweep Reverse 471
Freq Offset 471
Select Source 472
Add Installed USB Source 473
GPIB Address 474
Add Specified GPIB Address 474
Scan & Add GPIB Source 475
IP Address 475
Add Specified IP Address 475
Run Connection Expert… 475
Add From Connection Expert 475
Select Highlighted Source 476
Delete Highlighted Source 477
Verify Connection 477
Show Source 478
Source Preset 478
Source Setting Query (Remote Query Only) 479
3.2.9 Sweep 479
3.2.9.1 Sweep/Control 479
Sweep Time 480
Minimum Acquisition Time 483
Sweep/Measure 484
Sweep Time Annotation 486
Zoom Sweep Time 487
Spectrum Analyzer Mode User's &Programmer's Reference 11

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)