7 Save/Recall/Print
7.3 Save
Marker Table files have the extension .csv. The default filename is MeasR_
0000.csv, where the 4-digit number is the lowest number that does not conflict
with any filename in the current directory.
The default path for Marker Table data files is:
My Documents\<mode name>\data\<measurement name>\results
where <mode name> is the parameter used to select the mode with the :INST:SEL
command (for example, SA for the Spectrum Analyzer Mode) and <measurement
name> is the parameter used to select the measurement with the :CONF: command
(for example, SAN for the Swept SA measurement).
The Marker Table file contains a metadata header that describes the current state of
the instrument. The metadata is detailed below.
Remote Command
:MMEMory:STORe:RESults:MTABle <filename>
Example Save the results from the current marker table to the file myResults.csv in the current path:
:MMEM:STOR:RES:MTAB "myResults.csv"
Notes If the save is initiated via SCPI, and the file already exists, the file will be overwritten
Using the C: drive is strongly discouraged, since it runs the risk of being overwritten during an
instrument software upgrade
Both single and double quotes are supported for any filename parameter over SCPI
Dependencies If a save of Marker Table results is requested and Marker Table is not ON, no file is saved, and a
message is generated
In the Log Plot measurement, Marker Table is available only when Option N9068A-BFP is installed
Marker Table File Contents
This section discusses the Marker Table Meas Results file format.
Suppose that, at the point where a Marker Table Meas Result is requested, the
following screen is showing:
Spectrum Analyzer Mode User's &Programmer's Reference 2574
To Next Page
Loading...
Need help?
General
