Keysight x-series User Manual

8 Trigger
8.1 Trigger
Source SCPI Availability
In SA Mode, all measurements except ACP and
List Sweep
In WCDMA, MSR, Short Range Comms, VMA
and LTE Modes, all measurements except ACP
In WLAN Mode, all measurements
In Phase Noise Mode, all measurements except
Log Plot and Spot Frequency
"ADC Trigger" on page
2647
ADC
All Modes and measurements supporting Video
or Level, except Spectrum Analyzer mode
Only supported in certain model’s IF Paths
"Line" on page 2648
LINE
All Modes except EMI, Avionics and Analog
Demod
In SA Mode, all measurements except List
Sweep
In WLAN and GSM/EDGE Modes, all
measurements except Power vs. Time
In LTE and 5G NR Modes, all measurements
except Transmit On/Off Power
In Short Range Comms Mode, all measurements
except Modulation Analysis
In MSR Mode, all measurements
"External 1" on page
2648
EXTernal1
All Modes and measurements
"External 2" on page
2649
EXTernal2
All Modes and measurements
"External 3" on page
2649
EXTernal3
See "External 3 Support" on page 2636
"RF Burst" on page
2651
RFBurst
All Modes except EMI
In SA Mode, all measurements except List
Sweep
"Periodic" on page
2652
FRAMe
All Modes except EMI
In SAMode, all measurements except List
Sweep
"TV" on page 2654
TV
SA Mode only, and only in the Swept SA
measurement
2635 Spectrum Analyzer Mode User's &Programmer's Reference

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)