8 Trigger
8.1 Trigger
I/Q Triggers
"I/Q Mag" on page 2655
IQMag
All Modes except EMI, Avionics, RTSA, Analog Demod and Pulse
In SA Mode, only in Power Stat CCDF and Burst Power
In WCDMA Mode, only in Power Stat CCDF and IQ Waveform
In GSM/EDGE Mode, only in EVM, GMSK Phase & Freq Error, Transmit
Power and IQ Waveform
In Phase Noise Mode, only in IQ Waveform
In Bluetooth Mode, only in Transmit Analysis
In LTE Mode, only in Power Stat CCDF, Modulation Analysis,
Conformance EVM, and IQ Waveform
In WLAN Mode, only in Power Stat CCDF, Modulation Analysis,
Spectral Flatness, and IQ Waveform
In Short Range Comms Mode, only in Power Stat CCDF and
Modulation Analysis
In VMA Mode, only in Power Stat CCDF, Digital Demod and IQ
Waveform
In CQM Mode, only in Group Delay, Power Stat CCDF, and IQ
Waveform
"Input I" on page 2656
IINPut
"Input Q" on page 2656
QINPut
"I (Demodulated)" on page
2657
IDEMod
"Q (Demodulated)" on page
2657
QDEMod
"Aux I/Q Mag" on page
2658
AIQMag
"PXI" on page 2658
PXI
All Modes and measurements (only found in modular analyzers)
"Internal" on page 2659
INTernal
All Modes and measurements (only found in modular analyzers)
"Audio External" on page
2650
AEXTernal
Via the TRIG IN connector on the M9260A Audio Analyzer module
"Prot Channel Detection"
on page 2659
PRTChandet
Base Station Emulation; valid UL signal detected
(PUSCH/PUCCH/PRACH/SRS)
"Prot Frame Aligned" on
page 2660
PRTFrame
Base Station Emulation; periodic technology format radio frame with
data frame aligned to the BSE timing
"Prot Event" on page 2660
PRTEvent
Base Station Emulation events
External 3 Support
Trigger Source External 3 is available only in certain Modes and measurements, as
follows:
5GNR
Transmit On|Off, Modulation Analysis, Power Stat CCDF, and IQ Waveform measurements only
ADEMOD
Not supported
AVIONICS
Not supported
BT
Not supported
CQM
Group Delay, Power Stat CCDF, and IQ Waveform measurements only
EMI
Not supported
Spectrum Analyzer Mode User's &Programmer's Reference 2636
To Next Page
Loading...
Need help?
General
