Table Of Contents
5.14 Restart Instrument (Shutdown) 2221
5.15 Restart Application (Application Shutdown) 2222
5.16 System Log Off (Remote Command Only) 2223
5.17 Power Standby (Instrument Shutdown) 2224
6 Input/Output 2225
6.1 RF Source 2226
6.1.1 RF Output 2226
6.1.2 RF Output Port 2226
6.1.3 Half Duplex Output Port 2228
6.1.4 RF Power 2229
6.1.5 T/R Port High Power Attenuator 2229
6.1.6 Amplitude Setup 2229
6.1.6.1 RF Power 2229
6.1.6.2 Set Reference Power 2233
6.1.6.3 Power Ref 2234
6.1.6.4 Power Unit 2234
6.1.6.5 Amptd Offset 2235
6.1.6.6 Amplitude Increment 2236
6.1.7 Frequency 2236
6.1.8 List Sequencer 2236
6.1.8.1 Sequencer 2237
6.1.8.2 Initiate Sequence 2237
6.1.8.3 Repetition 2238
6.1.8.4 Trig Out Type 2238
6.1.8.5 Select Data Marker 2238
6.1.8.6 Manual Trigger Now 2239
6.1.8.7 List Sequencer Setup 2239
Number of Steps 2239
Go To Step 2239
Insert Step Before 2240
Delete Step 2240
Clear List 2240
Step Trigger 2240
Transition Time 2241
Band 2242
Device 2246
58 Spectrum Analyzer Mode User's &Programmer's Reference
To Next Page
Loading...
