Keysight x-series - Page 63

Table Of Contents
6.2.13.5 Delete All VDI CCD Corrections 2370
6.2.13.6 Harmonic 2370
6.2.13.7 LO Doubler 2371
6.2.13.8 Refresh USB Mixer Connection 2371
6.2.14 Mixer Path 2372
6.2.15 User IF Freq 2373
6.2.16 Signal ID On/Off 2373
6.2.17 Signal ID Mode 2374
6.2.18 Cable IF Loss 2375
6.2.19 I/Q Path 2376
6.2.20 Reference Z 2378
6.2.21 I/Q Setup 2378
6.2.21.1 I Setup 2378
Differential 2378
Input Z 2379
Skew 2380
Combined Differential/Input Z (Remote Command Only) 2381
6.2.21.2 I Probe 2381
Attenuation 2382
Offset 2383
Coupling 2383
Clear Calibration 2384
6.2.21.3 Calibrate 2384
I/Q Isolation Calibration 2385
I/Q Isolation Calibration Time (Remote Query Only) 2386
I Port 2386
I Port Probe Calibration Time (Remote Query Only) 2386
I-bar Port 2387
I-bar Port Probe Calibration Time (Remote Query Only) 2387
6.2.21.4 Q Setup 2387
Q Same as I 2387
Differential 2388
Input Z 2389
Skew 2390
6.2.21.5 Q Probe 2390
Attenuation 2390
Offset 2391
Coupling 2391
Clear Calibration 2392
6.2.21.6 Calibrate 2392
Spectrum Analyzer Mode User's &Programmer's Reference 63