To Next Page

To Previous Page

Table Of Contents

9.3.3.1 Clear Trace (Remote Command Only) 2757

9.3.3.2 Send/Query Trace Data (Remote Command Only) 2758

9.3.3.3 Format Data: Numeric Data (Remote Command Only) 2760

9.3.3.4 Format Data: Byte Order (Remote Command Only) 2761

9.3.3.5 Calculate/Compress Trace Data Query (Remote Command

Only) 2761

9.3.3.6 Calculate Peaks of Trace Data (Remote Command Only) 2767

9.3.3.7 Smooth Trace Data (Remote Command Only) 2769

9.3.3.8 Number of Points for Smoothing (Remote Command Only) 2770

9.3.3.9 Mean Trace Data (Remote Command Only) 2771

9.4 Status Register System & STATus Subsystem 2772

9.4.1 Status Register System Diagram 2772

9.4.2 Status Register Hierarchy 2774

9.4.3 Status Register SCPI Commands 2776

9.4.4 How to Use Status Registers 2777

9.4.4.1 Polling Method 2777

Monitoring Options 2778

9.4.4.2 Service Request (SRQ) Method 2778

Using the Service Request (SRQ) Method 2778

9.4.5 Status Register Bit Parameters 2780

9.4.6 Status Subsystem Registers and Commands 2781

9.4.6.1 Status Byte Register 2781

Service Request Enable Register 2784

Preset the Status Byte 2784

9.4.6.2 Standard Event Status Register 2785

Standard Event Status Enable Register 2786

9.4.6.3 Operation Register 2787

Operation Condition Query 2788

Operation Enable 2789

Operation Event Query 2789

Operation Negative Transition 2790

Operation Positive Transition 2790

9.4.6.4 Operation Instrument Register 2791

Operation Instrument Condition 2791

Operation Instrument Enable 2792

Operation Instrument Event Query 2792

Operation Instrument Negative Transition 2793

Operation Instrument Positive Transition 2793

76 Spectrum Analyzer Mode User's &Programmer's Reference

Keysight x-series User Manual

Other manuals for Keysight x-series