Keysight x-series User Manual

Table Of Contents
I 2717
L 2718
M 2718
O 2720
R 2720
S 2721
T 2742
U 2743
9.2 IEEE 488.2 Common Commands 2744
9.2.1 *CAL? - Calibration Query 2744
9.2.2 *CLS - Clear Status 2745
9.2.3 *ESE - Standard Event Status Enable 2745
9.2.4 *ESR? - Standard Event Status Register Query 2746
9.2.5 *IDN? - Identification Query 2746
9.2.6 *OPC? - Operation Complete 2747
9.2.7 *OPT? - Query Instrument Options 2748
9.2.8 *RCL - Recall Instrument State 2748
9.2.9 *RST - Reset 2748
9.2.10 *SAV - Save Instrument State 2749
9.2.11 *SRE - Service Request Enable 2749
9.2.12 *STB? - Status Byte Query 2750
9.2.13 *TRG - Trigger 2750
9.2.14 *TST? - Self Test Query 2750
9.2.15 *WAI - Wait-to-Continue 2751
9.3 SCPI Operation and Results Query 2752
9.3.1 Mode Control 2752
9.3.2 Measurement Control 2752
9.3.2.1 CONFigure 2753
9.3.2.2 INITiate 2754
9.3.2.3 FETCh 2754
9.3.2.4 READ 2755
9.3.2.5 MEASure 2756
9.3.3 Trace Formatting Commands 2757
Spectrum Analyzer Mode User's &Programmer's Reference 75

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)