January 2007
2-82
WorkCentre 7132
005-160, 005-190
Revision
Status-indicator-raps
005-160 DADF Tray Lift Up Fail on running (Document Set)
BSD-ON:5.4
The following is detected: Level Sensor does not turn On or Bottom Sensor does not turn On in
specified time from start of Tray Lift Up when document is set. (Detected during Run, during
Stop, or during Purge)
Procedure
When the document is removed, this fault is released. When this problem occurs frequently,
check Level Sensor output/Tray Motor operation/Tray Drive system (Torque Limiter)/Sensor
Actuator.
Check the connectors and wires for damage.
If all above are OK, replace the DADF PWB (PL 16.3).
005-190 Feed Motor Logic Error Jam
BSD-ON:5.5
Feed Motor, rotating CW, does not start CCW rotation (Invert start) in specified time from Invert
Sensor Off (Invert operation)
Procedure
Follow the instructions displayed on UI
To Next Page
Loading...
