January 2007
2-509
WorkCentre 7132
035-746 , 035-747
Status-indicator-raps
Revision
035-746 Fax Protocol RAP
BSD-ON:16.1/17.1
The Fax controller detected one of the following:
• No DT1 signal before dialing.
• A BT1/BT2 signal before dialing.
• A CT1 signal before dialing (a state in which PBX is busy).
• A CT2 signal before dialing.
• No DT1 signal during dialing (This could happen when an outside line was used without
any signal sending from the PBX).
• A BT1/BT2 signal during dialing.
• A CT1/CT2 signal during dialing.
• No 2nd DT2 signal during dialing.
• A BT1/BT2 signal during dialing.
• A CT1/CT2 signal during dialing.
• No third DT3 signal during dialing.
• A BT1/BT2 signal during dialing.
• A CT1/CT2 signal during dialing.
• A BT1/BT2 signal after dialing.
• A CT1/CT2 signal after dialing.
• No DT signal from the PBX before dialing.
• A BT signal from the PBX before dialing.
• A CT signal from the PBX before dialing.
• A BT signal from the PBX after dialing.
• A CT signal from the PBX after dialing.
Procedure
Check the electrical connections on the FCB PWB (PL 11.3)
If the problem persists perform GP 2 Fax Checkout.
If the connections are good then there is a problem with the customers PBX (Private Branch
Exchange) line or the receiving fax.
035-747 Fax Protocol RAP
BSD-ON:16.1/17.1
The operation was stopped during dialing by using the Stop button.
Procedure
The customer terminated the transmission. Ask customer to resend the job.