January 2007
4-108
WorkCentre 7132
REP 12.3.1, REP 12.6.1
Reversion 4.0
Repairs/Adjustments
Figure 2 Removing the Feed/Retard/Nudger Roll
Replacement
1. To install, carry out the removal steps in reverse order.
2. When replacing, enter Diag. mode. Clear the counter.
REP 12.6.1 2TM PWB
Parts List on PL 14.7
Clean
Replacement
WARNING
To avoid personal injury or shock, do not perform repair or adjustment with electrical
power applied to the machine.
CAUTION
Check that “Ready to Copy” is displayed on the Control Panel display.
1. Before replacing the 2TM PWB, read and record the values at NVM location 742-022 and
742-023.
2. When replacing the 2TM PWB, set the 2TM PWB Dip Switch to the position as shown.
(Figure 1)
To Next Page
Loading...
Need help?
General
