EasyManuals Logo

Xerox WorkCentre 7132 Service Documentation

Xerox WorkCentre 7132
1726 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1212 background imageLoading...
Page #1212 background image
January 2007
4-261
WorkCentre 7132
ADJ 11.6.1
Repairs/Adjustments
Reversion 4.0
ADJ 11.6.1 Full/Half Rate Carriage Position Adjustment
Purpose
To adjust the position of the Full/Half Rate Carriage.
Adjustment
WARNING
To avoid personal injury or shock, do not perform repair or adjustment with electrical
power applied to the machine.
CAUTION
Check that “Ready to Copy” is displayed on the Control Panel display.
NOTE: Adjust the position of the Front and Rear Full/Half Rate Carriage separately.
1. Switch off the power and disconnect the power cord.
2. Remove the Platen Glass. (REP 11.3.1)
3. Remove the Lens Assembly cover. PL 13.4
4. Prepare the tools (2) for determining the position. (Figure 1)
1. Remove the screws (2).
2. Take out the tools (2).
Figure 1 Taking out the tools
5. Align the tool hole in the Half Rate Carriage with the tool hole of the rail (Front/Rear). (Fig-
ure 2)

Table of Contents

Other manuals for Xerox WorkCentre 7132

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Xerox WorkCentre 7132 and is the answer not in the manual?

Xerox WorkCentre 7132 Specifications

General IconGeneral
BrandXerox
ModelWorkCentre 7132
CategoryAll in One Printer
LanguageEnglish

Related product manuals