January 2007
3-30
WorkCentre 7132
Auger Marks Defect (Black), Auger Marks Defect (Ma-
Reversion 4.0
Image Quality
• Monotone image over the whole print with coverage between 40 and 60%.
• High temperature and high humidity.
Corrective Action
If the defect is worse than the defect sample, replace the Developer Unit (PL 5.2).
Auger Marks Defect (Magenta)
Figure 1 Auger Marks Image Defect Sample (VA-003)
Cause
Auger marks may appear on the prints when the amount of toner becomes low in the Devel-
oper Unit.
The following conditions increase the defect:
• Monotone image over the whole print with coverage between 40 and 60%.
To Next Page
Loading...
