January 2007
6-196
WorkCentre 7132
Hard Disk Diagnostic Program, Test Pattern Print
Reversion 4.0
General procedures information
Hard Disk Diagnostic Program
Purpose
NOTE: HDD initialization using the UI-Diagnostic is only for Partition A.
Procedure
1. Access Diagnostic Routines.
a. Enter UI Diagnostics (Entering UI Diagnostics in UI Diagnostic Mode).
b. Access Diagnostic Routines (Accessing Diagnostic Routines in UI Diagnostic
Mode).
2. Select Sub System.
3. Select Initialize Hard Disk and select Partition A.
4. Press the Start button and select Yes.
5. When Partition A has been initialized is displayed, select Confirm.
NOTE: After the above procedure, Partition A will be initialized.
Test Pattern Print
Purpose
Prints the test patterns in the machine, to help identify Image Quality problems.
Procedure
1. Enter UI Diagnostic Mode.
2. Select Print Test Pattern.
3. Enter Pattern Number. Select a Test Pattern number from Table 1.
4. Select Paper Supply
5. Select Paper Tray.
6. Select Save.
7. Select Output Color.
Ensure that the Output Color is 4C.
8. Select Save.
9. Select Quantity.
Enter the number of print desired by pressing the Up/Down arrows.
10. Select Cin%. The higher the percentage, the darker the image will be.
NOTE: Choose 20% to 50% initially for good image visibility.
11. Press Start.
NOTE: If IOT Subsystem Fail occurs during Test Print, IOT and subsequent Diagnostics can-
not be processed causing an error. Test Print cannot be canceled and the power must be
turned Off/On (However, it is possible to exit Diagnostics).
If Not Ready states such as Device Error, Jam and No Paper are the cause of the error, Diag-
nostics can be processed and Test Print can be canceled.
As the MC competes with the contents of the instructions from the UI, the machine may print
the specified test pattern or use the priority tray, or it may not print and send a message indicat
-
ing that a conflict occurred.
The UI receives this message from the MC and displays a message indicating that an error
occurred and printing is possible due to a conflict in the operation.
When a jam occurs, the machine stops processing (do not continue or process again). The
Clear Jam screen appears and a message asking the user to clear the jam will be displayed on
the UI.
Test Patterns
For details on the test pattern generation location and output path, see Table 1.
Table 1 Pattern Outline
No. Pattern Name
Output Color and paper size available for this
pattern
Built-in Image
Sub
1 YCMK Grid Pat-
tern
4C 11x17” paper IOT
51 Grid Pattern 4C IOT
52 Total Chart-MT-K1 4C IOT
53 Process Control 4C IOT
To Next Page
Loading...
Need help?
General
