Xerox WorkCentre 7132

January 2007
4-168
WorkCentre 7132
REP 16.6.2, REP 16.7.1
Reversion 4.0
Repairs/Adjustments
REP 16.6.2 Finisher Drive Motor
Parts List on PL 17.6
Removal
WARNING
To avoid personal injury or shock, do not perform repair or adjustment with electrical
power applied to the machine.
CAUTION
Check that “Ready to Copy” is displayed on the Control Panel display.
1. Remove the Rear Cover. (REP 16.4.1)
2. Remove the Finisher Drive Motor. (Figure 1)
1. Disconnect the connector.
2. Remove the screws (x4).
3. Remove the Finisher Drive Motor.
Figure 1 Removing the Finisher Drive Motor
REP 16.7.1 Paper Eject Belt
Parts List on PL 17.7
Removal
WARNING
To avoid personal injury or shock, do not perform repair or adjustment with electrical
power applied to the machine.
CAUTION
Check that “Ready to Copy” is displayed on the Control Panel display.
1. Remove the Rear Cover. (REP 16.4.1)
2. Turn the actuator. (Figure 1)
1. Turn the actuator in the direction of the arrow.
Figure 1 Turning the actuator
3. Release the clamp to remove the wire. (Figure 2)