Xerox WorkCentre 7132

January 2007
6-205
WorkCentre 7132
GP 4, GP 5
General procedures information
Reversion 4.0
13. If any PWB will not synchronize, replace that PWB and re-synchronize.
14. Restore all Service Log Settings, Factory Settings and Customer Settings (GP 9)
GP 5 Printing Reports
Description
This procedure describes how to print reports.
Procedure
Refer to types of reports below.
System Settings List
Printing the System Settings List (Configuration Report) without entering Diagnostics Mode.
NOTE: Other report titles are also listed for your information
NOTE: If paper size errors occur when attempting to print reports, check that NVM location
700-397 is set for the appropriate paper size (44 = 8.5 x 11 in.; 5 = A4) (refer to NVM Read/
Write).
1. Press the Machine Status button on the Control Panel.
2. Select Billing Meter/Print Report tab on the display.
3. Select Print Report/List.
4. Select the following tabs to print the selected reports.
• Job Status/Activity Report
– Job History Report
– Activity Report
– Error History Report
– Stored Documents List
• Scan Mode Settings
– Settings List
– Job Template List
–Address Book
• Copy Mode Settings
– Settings List-Common Items
• FAX Mode Settings
– Settings List
–Address Book
– Comments List
• Print Mode Settings
– Settings List-Common Items (will be selected in next step)
– PCL Settings List
–PCL Form List
– PDF Settings List
– TIFF Settings List
– TIFF Logical Printers List
– PS Logical Printers List
– Fonts List
– PostScript Fonts List