Xerox WorkCentre 7132 Service Documentation

January 2007
2-810
WorkCentre 7132
123-332, 123-333
Revision
Status-indicator-raps
123-332 Interface Parameter RAP
The UI software failed and an incorrect parameter was received by the DM-CP driver interface.
Initial Actions
Power Off/On
Procedure
Disconnect and reconnect the electrical connections on the UI PWB (PL 13.2) and P/J388 on
the ESS PWB (PL 11.2)
If the problem persists reload Software (ADJ 9.3.1).
If the problem persists replace the UI PWB (PL 13.2).
If the problem persists replace the ESS PWB (PL 11.2).
123-333 Interface Communication RAP
The system detected that transmission with the Control Panel could not be established.
The H/W connection in the UI is faulty and the internal connection isn’t detected.
Initial Actions
Power Off/On
Procedure
Disconnect and reconnect the electrical connections on the UI PWB (PL 13.2) and P/J388 on
the ESS PWB (PL 11.2)
If the problem persists reload Software (ADJ 9.3.1).
If the problem persists replace the UI PWB (PL 13.2).
If the problem persists replace the ESS PWB (PL 11.2).

Xerox WorkCentre 7132 Specifications

General

Brand	Xerox
Model	WorkCentre 7132
Category	All in One Printer
Language	English