January 2007
2-108
WorkCentre 7132
005-919, 005-940
Revision
Status-indicator-raps
005-919 DADF Tray Lift Up Failure not during Job
The following detected:
With the document being set, Level Sensor does not turn On or Bottom Snr does not turn Off in
a specified time from start of Tray Lift Up.
Detected except for During Run, during Stop, or during Purge.
Procedure
Removal of set document cancels the fault. If it occurs frequently, check the Level Sensor, Tray
Motor, Tray Drive Assembly, area for binding, damage, and/or debris. Check the connections
between the Level Sensor and the DADF PWB. If OK, replace the Level Sensor. If the problem
persists, replace the DADF PWB (PL 16.3).
005-940 DADF No Original Failure
Removal of Documents detected.
Procedure
Follow instructions on the UI Screen
To Next Page
Loading...
