EasyManuals Logo

Xerox WorkCentre 7132 Service Documentation

Xerox WorkCentre 7132
1726 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #807 background imageLoading...
Page #807 background image
January 2007
2-774
WorkCentre 7132
116-383, 116-385
Revision
Status-indicator-raps
116-383 PIT Lib Failure RAP
(1) It was detected that the Image Extension Kit (Ama + toto board) was not installed on the
controller board during job execution.
(2) An Ama + toto board failure was detected during job execution.
(3) An HDD access error was detected during job execution.
* Note that although 016-231 is detected during power ON, this fail is a “job execution detec-
tion” and has a different timing.
Procedure
(1) (2) After turning the power OFF then ON, check the panel top right display to see whether
016-231 has occurred, without this error (= 116-383) occurring.
If 016-231 has occurred, perform the corrective actions for 016-231.
If the error does not occur, proceed to (3) for the HDD access error.
116-385 IDC Software RAP
An internal shutdown occurred after an IDC (scripting language) processing error.
Initial Actions
Power Off/On
Procedure
Reinstall or replace the DIMM (PL 11.2).
If the problem persists reload Software (ADJ 9.3.1).
If the problem persists, replace the ESS PWB (PL 11.2).

Table of Contents

Other manuals for Xerox WorkCentre 7132

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Xerox WorkCentre 7132 and is the answer not in the manual?

Xerox WorkCentre 7132 Specifications

General IconGeneral
BrandXerox
ModelWorkCentre 7132
CategoryAll in One Printer
LanguageEnglish

Related product manuals