January 2007
2-98
WorkCentre 7132
005-307, 005-906
Revision
Status-indicator-raps
005-307 CVT Platen Interlock Open on Running RAP
BSD-ON:6.1
The Platen Interlock is open while the DADF is running (RUN/SUSPEND).
Initial Actions
• Power Off than On
Procedure
Check opening/closing of the Platen Cover. The Platen Cover can be opened/closed.
YN
Reinstall the Platen Cover correctly.
Check the installation of the Platen Open Switch. The Platen Open Switch is installed cor-
rectly.
YN
Install the Platen Open Switch correctly.
Execute Component Control [062-300 Platen Open Switch]. Open and close the Platen
Cover. The display changes.
YN
Check the connections of P/J727 and P/J722. P/J727 and P/J722 are connected cor-
rectly.
YN
Connect P/J727 and P/J722.
Check the wire between J727 and J722 for an open circuit or a short circuit (BSD 6.1 Flag
3/Flag 4).
The wire between J727 and J722 is conducting without an open circuit or
a short circuit.
YN
Repair the open circuit or short circuit.
Check the conductivity of the Platen Open Switch between J722-A10 and J722-A11 (BSD
6.1 Flag 3/Flag 4).
The wire between J722-A10 and J722-A11 is connecting success-
fully when the Platen Open Switch contact is closed, and is insulated when the con-
tact is opened.
YN
Replace the Platen Open Switch (PL 13.4).
Replace the IIT/IPS PWB (PL 13.3).
Replace the IIT/IPS PWB (PL 13.3).
005-906 CVT Feed Sensor RAP
BSD-ON:5.4
Paper remains on the DADF Feed Out Sensor.
Initial Actions
• Remove the paper.
• Power Off than On
Procedure
Execute Component Control [005-205 DADF Feed Out Sensor]. Actuate the DADF Feed Out
Sensor with paper.
The display changes.
YN
Check the connections of P/J769 and P/J758. P/J769 and P/J758 are connected cor-
rectly.
YN
Connect P/J769 and P/J758.
Check the wire between J769 and J758 for an open circuit or a short circuit (BSD 5.4 Flag
13/Flag 14).
The wire between J769 and J758 is conducting without an open circuit
or a short circuit.
YN
Repair the open circuit or short circuit.
Measure the voltage between the DADF PWB P758-3 (+) and GND (-) (BSD 5.4 Flag
14).
The voltage is approx. +5VDC.
YN
Replace the DADF PWB (PL 16.3).
Measure the voltage between the DADF PWB P758-2 (+) and GND (-) (BSD 5.4 Flag 13).
Actuate the DADF Feed Out Sensor with paper. The voltage changes.
YN
Replace the DADF Feed Out Sensor (PL 16.9).
Replace the DADF PWB (PL 16.3).
Replace the DADF PWB (PL 16.3).
To Next Page
Loading...
Need help?
General
