EasyManuals Logo

Xerox WorkCentre 7132 Service Documentation

Xerox WorkCentre 7132
1726 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #57 background imageLoading...
Page #57 background image
January 2007
2-34
WorkCentre 7132
003-344, 003-345
Revision
Status-indicator-raps
003-344 Hotline Power On
BSD-ON:3.1/6.2
There is a communication failure at power on between the controller and the IIT.
Initial Actions
Power On/Off
Procedure
Disconnect and reconnect the IIT/IPS PWB Harness.
If the problem persists replace the IIT/IPS PWB (PL 13.3).
If the problem persists replace the ESS PWB (PL 11.2).
003-345 PIO Unlatched 1 RAP
BSD-ON:3.1/6.2
When Job Fail signal was received from the IIT/IPS PWB, a hot line PIO (Programmed Input
Output) error was detected.
Procedure
Disconnect and reconnect the IIT/IPS PWB Harness.
If the problem persists replace the IIT/IPS PWB (PL 13.3).
If the problem persists replace the ESS PWB (PL 11.2).

Table of Contents

Other manuals for Xerox WorkCentre 7132

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Xerox WorkCentre 7132 and is the answer not in the manual?

Xerox WorkCentre 7132 Specifications

General IconGeneral
BrandXerox
ModelWorkCentre 7132
CategoryAll in One Printer
LanguageEnglish

Related product manuals